| | Below is the drawing for the Die Springs I am building. I am having some problems deciding if this design will work as the spring is not removable as shown I drew the drawing below from some other plans posted elsewhere that I simply re drew for clarity. So, I am looking for a solution that will allow me to remove the spring. I have tube one finished with the lower washer welded in place but I am thinking I may need to re do it in some manner to make the spring removable. Any suggestions???
|
| | Posted 2/16/2009 12:35 AM - 6 Views - 0 eProps - 0 comments
- recommend
  - recs0
- share
- email
 - sent0
|
